In order to reset the oil change indicator light on a 2008 ford explorer sport trac, you should turn the ignition on without starting the engine, press and hold the select button for two seconds, and then press the button again until oil life reset and start value are displayed on the screen.
How do you reset the oil life on a 2008 Ford Explorer?
In order to reset the oil change indicator light on a 2008 ford explorer sport trac, you should turn the ignition on without starting the engine, press and hold the select button for two seconds, and then press the button again until oil life reset and start value are displayed on the screen.
How do you reset the oil change light on a Ford Explorer?
Turn the ignition to the ON position. Do not start the engine. Press and release the “Select/Reset” stem button on the instrument panel to toggle the options until the “Hold Reset For Setup Menu” option appears. Press “Select/Reset” to toggle the options until the “Hold Reset if New Oil” option appears.
How do you reset the oil change light on a 2007 Ford Explorer?
Where is the oil change reset button?
How do I reset my dashboard after oil change?
Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again.
What does it mean when car says oil change required?
What does it mean if the message center says “oil change required”? … If the oil is allowed to go beyond the end of its life, it loses its ability to lubricate (called viscosity), and it builds up debris and can cause damage to your engine. Your car is designed with an oil change reminder system.
What does the wrench light mean on a 2007 Ford Explorer?
The wrench light on a 2007 Ford Explorer means that it is time for a service on the vehicle. Usually it will be something simple like an oil change, but could be more involved like a transmission fluid change. It is impertinent to always keep up on the maintenance with Your vehicle.
How do I reset my Ford Explorer?
How do I reset the oil change light on a 2006 Ford Explorer?
How do I reset my warning light?
Why won’t my change oil light go off?
Check the oil. The light is a warning signal that you are low on oil or that the oil is not flowing properly. If the oil level is fine then the issue may be a reset button. Two different methods will allow you to reset the oil light.
How do I reset my service light?
Start with the ignition turned ON (position 2), but with the engine OFF. Pull out and hold the button on the right side of the display until “SERVICE” appears on the display. Release the button on the right, then within 5 seconds pull the button out and hold it again.
How do you reset car sensors?
Leaving the battery disconnected for about 15 minutes will ensure the vehicle systems will completely reset when you reconnect the battery. … Disconnecting the battery will clear the error codes and reset the check engine light.
Why is my engine light on after oil change?
These lights can signal something serious or something as simple as a loose gas cap. Regardless, diagnosing the problem is key. One thing that won’t trigger a check engine light: a recent oil change that was done correctly. … If you notice the light after an oil change, something else is wrong.
How do I reset my oil percentage?
Step 1: Turn your Civic ignition on without starting your engine or press the start button twice without touching the brake. Step 2: Press the Trip knob repeatedly until the Engine Oil Life percentage displays. Step 3: Press and hold the trip knob until the Engine Oil Life percentage starts to blink.