To reset the Dodge Ram throttle position sensor(TPS), You need to turn on the ignition without Your foot on the brake, so the engine doesn’t start. Then press the accelerator on the floor for 15 seconds. Release the accelerator. Then turn the car off and start the engine and drive.
How do you reset the throttle control on a Dodge?
To reset the Dodge Ram throttle position sensor(TPS), You need to turn on the ignition without Your foot on the brake, so the engine doesn’t start. Then press the accelerator on the floor for 15 seconds. Release the accelerator. Then turn the car off and start the engine and drive.
Do you have to reset computer after replacing throttle position sensor?
After replacing the throttle body to your engine, if the engine light was on and has a pending code, the code will go away. If the code was a hard permanent code, then the ECM (computer) would need a hard reset. … The engine light will go out and clear all codes as it goes into a learn cycle.
How do you relearn the throttle position sensor?
Here’s the throttle body relearn procedure
1) Start the engine and let it idle in park for 3 minutes. During that period the idle may be higher idle than normal. 2) After 3 minutes, turn the engine off and leave it off for 60- seconds. 3) Start the engine again and let it idle in park for 3 minutes one more time.
How do I reset my electronic throttle control?
Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.
What are the signs of a bad throttle position sensor?
How do you reset the accelerator pedal position sensor?
To recalibrate the ECM and accelerator pedal, the ignition switch must be in the ON position and then the accelerator pedal must be slowly and fully depressed from idle to full throttle. Repeat the procedure three times.
How do you fix a throttle position sensor?
Can I unplug my TPS sensor?
If the TPS is not adjusted correctly as evidenced by a 500rpm idle, and hesitation with initial acceleration, unplugging the TPS connector should then cause a correct idle, and a normal acceleration. Correcting the TPS then produced a correct idle, and no code.
How long does it take for a throttle body to relearn?
1) Start the engine and let it idle in park for 3 minutes. During that period the idle may be higher idle than normal. 2) After 3 minutes, turn the engine off and leave it off for 60- seconds. 3) Start the engine again and let it idle in park for 3 minutes one more time.
How do I fix my electronic throttle control?
Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.
What causes an electronic throttle control to go bad?
In this case, the problem may be caused by a miscommunication link from the throttle controller and the engine’s air fuel mixture which is regulated by the mass air flow sensor on many cars. … In most cases, issues with the throttle controller are electric, either caused by a damaged sensor or electrical relay.
Can throttle control make car not start?
When a TPS goes bad, then the car’s throttle body won’t function properly. It could either stay shut or it won’t close properly which is a severe issue. If it stays shut then your engine is not going receive air and it won’t start.
Is there a way to test a throttle position sensor?
Turn the key ON without starting the engine, ensuring the throttle is fully closed. If the digital multimeter reads between . 2 to 1.5 volts, then the throttle position sensor is working correctly. As you open the throttle plate, the digital multimeter should increase to 5 volts.
Is it OK to drive with a bad throttle position sensor?
Can you drive with a bad throttle position sensor? It is not a good idea to drive with a bad throttle position sensor. Driving your car in this condition can be dangerous because your car might not accelerate properly or could suddenly accelerate without the driver pressing the gas pedal.
How much does it cost to replace a throttle position sensor?
The average cost for a Throttle Position Sensor Replacement is between $155 and $199 but can vary from car to car.